Argorev HCF

Argorev HCF mortar is ideal for exterior rendering and interior plasterwork, applied in a thin layer (approx. 5 mm) on a levelled mortar support. Particularly suitable for impermeable and decorative finishes on walls, patios, etc.

The approximate yield of Argorev HCF is 8 kg/m² when applied to a thickness of 5 mm.

25 kg sacks (1000 kg pallet).

In the original container in a covered area, for up to 12 months.

The support should be sturdy, flat, as rough as possible and free of dust, paint, oil, etc. If exposed to direct sunlight or highly absorbent, wetting is advisable first.

1. Mix mechanically with clean water until an even, plastic mixture is achieved, without any lumps, using 20% water (approx. 5 l/sack).
2. Leave the mixture to stand for 5 minutes and then remix before applying.
3. For coating, spreads over the support with a trowel and leave for as long as necessary before smoothing off (10-15 minutes, depending on the support, temperature and ambient humidity).
 

Do not apply onto gypsum-based surfaces. Do not apply onto supports or parts with poor or zero absorption.
Do not apply at extreme temperatures (below 5 ºC or above 35 ºC).

Mixing water approx. (%): 20
Max. aggregate size (mm): 1
Apparent powder density (g/cm³): 1.5
Apparent paste density (g/cm³): 1.9
Lifetime of mix (mins): 180
Bending strength (N/mm²): ≥2.0
Crushing strength (N/mm²): ≥6.0
Tensile strength (N/mm²): ≥0.3
Capillarity (dm².min½): <1.4