Argotec Waterproof 100

Argotec Waterproof 100 can be applied in interiors and exteriors and is suitable for the following tasks:
Waterproofing water tanks, swimming-pools, basements, etc.
Waterproofing foundations, slabs and walls.
Waterproofing to protect from filtration by surface water or groundwater.
Protecting buildings against damp.
 

Non-pressurised water Thickness: 2 mm Yield: 4 Kg/m²
Pressurised water Thickness: 5 mm Yield: 10 Kg/m²
 

20 kg sacks (800 kg pallet).

In the original container in a covered area, for up to 12 months.

Supports should be firm, clean, moist but not wet and free of paint, oil, formwork remover, etc.
Smooth or non-absorbent supports should be treated first by sandblasting.
Supports that could undergo shifting or with minor cracks should be waterproofed with Argotec Waterproof 300 or 500.
 

1. Mix mechanically with clean water until a fluid consistency is achieved, 20% (approx. 4.0 l/sack).
2. Raise the consistency of the product for the first coat by adding almost 1 litre more water, as this coat is applied by brush.
3. Apply the second coat when the first is still fresh, using a trowel. If the final thickness required is >4 mm, apply 3 coats.
 

Do not apply at extreme temperatures (below 5 ºC or above 35 ºC).
Protect from wind and direct sunlight.
Cure the surface for the first 24 hours with curing liquid or with water, if drinking-water tanks are being waterproofed.
 

Grain size (mm) 0/0.5
Mixing water approx.(%): 20
Apparent density of powder: 1.4
Apparent density when fresh: 1.8
Mix lifetime (mins): 60
Applicable thickness: 1-5
Impermeability (atm): Up to 1.5
Capillary absorption (Kg/m²h½): 0.02
Permeability to water vapour: Class III
Direct tensile absorption (N/mm²): ≥1.0
Permeability to CO2: So>50 m
Crushing strength (N/mm²): 25