Argotec Fast

Argotec Fast is recommended for traditional brickwork whenever very fast setting is and high resistance within a short time is required. It is suitable for anchoring banisters, window bars, fitting rules, frames, etc.

Approx. 20 Kg/m² when applying a thickness of 10 mm.

25 kg sacks (1000 kg pallet).

In the original container in a covered area, for up to 12 months.

Supports should be firm, clean and as rough as possible, free of dust, paint, oil, formwork remover, etc.

1. Mix with water, manually or mechanically, until a fluid consistency is achieved (20% water) approx. 5.0 l/sack).
2. Immediately after mixing, carry out the task and then clean the utensils used straight away.
 

Do not apply onto gypsum-based surfaces.
Do not apply at extreme temperatures (below 5 ºC or above 35 ºC).
Protect from wind and direct sunlight.
 

Mixing water approx.(%): 20
Grain size (mm) 0/0.5
Apparent density of powder: 1.5
Apparent density when fresh: 1.9
Mix lifetime (mins): 5
Direct tensile adhesion (Mpa): ≥0.8
Capillary absorption (Kgm²h½): ≤0.5
Chloride-ion content (%): ≤0.05
Freeze/thaw thermal compatibility (Mpa): ≥0.8
Crushing strength:
After 1 hour (N/mm²): ≥5.0
After 2 hours (N/mm²): ≥7.0
After 28 days (N/mm²): ≥15.0